by oliver4116 » Tue Jan 26, 2016 2:17 am
Hi Jim hope that you are well, with the jubilee machine you were spot on with that, i took the tube off and just like you said a 5 cent piece was lodged sideways therefore jamming the slider, took it out put back together works like a dream, so thank you very much with that and you were right it was a very easy fix
With the Aristocrat have a few Photographs to show what i have been up to, with the first picture i tested the 3 wires there and none came up with a fault, but wanted to check with you to see if i am testing them right, i put one lead on the wire and the other on the metal frame, if i am doing it right they came up with no fault, but bit worried if i am doing the testing right with that one.
The other Photo shows the center wire of socket 4 and how it goes back to a whole pile of wires at the rear of the machine, and then upwards to the top of the machine where the fuses are. Again i am not sure wether i am testing that wire right, should i be putting one lead on the wire and the other lead on the frame or something i am not to sure, i guess we are trying to follow the short from socket 4 and am worried i am not testing that wire correctly.
Well i will leave it with you when you have a minute, good result with the jubilee so thanks again
- Attachments
-
-