Mills Fok needs a weld

This is the area to talk about everything regarding repairing and restoring machines.

Mills Fok needs a weld

Postby sam2002 » Tue Feb 02, 2016 5:18 pm

looking for someone that can weld a broken goosneck top casting . Narrow side of the upper casting has been broken off , left side looking from back . About 2 inches back it was broke when found .
thanks
Sam
sam2002
 
Posts: 702
Joined: Wed Feb 01, 2012 4:45 pm

Re: Mills Fok needs a weld

Postby oldslotman » Tue Feb 02, 2016 6:18 pm

John's Custom Fabrication Blooming Mn. I believe fellow member on here, terick2104, has used him. Might want to contact him about it.
oldslotman
 
Posts: 1139
Joined: Mon Feb 18, 2013 12:49 pm
Location: Bellevue, Nebraska

Re: Mills Fok needs a weld

Postby terick2104 » Wed Feb 03, 2016 4:37 am

Yes I have used him for over 20 years on castings and mechanisms. He does fabulous work, I have had castings that were missing chunks out of the castings that he repaired and I couldn't see where the repair was. I have had several goosenecks repaired by him also. Check out his web sight, put Johns Custom Fabrication in you search engine.
His phone # is 952-888-2322
terick2104
 
Posts: 185
Joined: Tue Jan 01, 2013 4:32 am

Re: Mills Fok needs a weld

Postby sam2002 » Wed Feb 03, 2016 3:27 pm

Will check into this .
Thank you !
sam2002
 
Posts: 702
Joined: Wed Feb 01, 2012 4:45 pm


Return to Repair / Restoration Questions

Who is online

Users browsing this forum: No registered users and 19 guests