mechanic wrote:Push down on the main operating lever aka pork chop and try to release the ratchet pawl at the top so that the mech can go back to zero. Then put all parts back into proper position. If the lift dog does not raise the main operating fork then the lift pin aka chisel will need to be adjusted back until the lift dog can pass by cleanly and then return back to zero position.
MONTI wrote:Mechanic is correct!
And a picture of your slot mech from an angle similar to the one below would help diagnose your problem as well!
This picture shows the lift pin adjustment that may be out of timing and if necessary what to loosen to adjust it!
Bona Fortuna!
MONTI
radiorich123 wrote:Yes that spring and the bar need to be corrected so it works correct.
Rich
Return to Repair / Restoration Questions
Users browsing this forum: No registered users and 50 guests