Page 3 of 3

Re: Mills Hightop 10 Cent - Payout issue

PostPosted: Wed Nov 07, 2018 11:13 pm
by oldslotman
I would try the payouts again only make sure you have at least 30 to 40 dimes loaded in the machine before testing. Sometimes with a dime machine if there are to few dimes in the machine they will tend not to feed the payout slides correctly. You need the weight of the additional dimes.

Re: Mills Hightop 10 Cent - Payout issue

PostPosted: Thu Nov 08, 2018 8:03 am
by CoinOpNick
Hi oldslotman - thanks for the update and no worries on the wrong info initially as you got to me before I was even able to locate a replacement. So I guess that means it is okay that the master slide is slightly off from the rest as it appears to be as designed. I will do as you suggested and load it with a good amount of dimes and see if I still have the issue. Thanks for your help and the others who have responded.

Re: Mills Hightop 10 Cent - Payout issue

PostPosted: Wed Nov 14, 2018 8:48 pm
by mikesoldtoys

Re: Mills Hightop 10 Cent - Payout issue

PostPosted: Thu Nov 15, 2018 10:34 am
by CoinOpNick
I did confirm the payslides are correct as being 10 Cent as they fit a dime perfectly. I believe my issue might be I installed some washers between the slide posts and the cover as without them the fit was too tight. I think this caused an issue them being too loose. So I am working on that.