Handle for Jennings console slot wanted

Looking for a particular machine? Ask for it here!

Handle for Jennings console slot wanted

Postby tsparts4u » Sun Jan 27, 2013 2:15 pm

WANTED:
I'm in need of a handle for a Jennings console slot machine like the one in the picture below. Can anyone help?
Attachments
MVC-307S.JPG
tsparts4u
 
Posts: 223
Joined: Fri Mar 02, 2012 6:58 pm
Location: Franklin, WI

Re: Handle for Jennings console slot wanted

Postby Jackpot » Sun Jan 27, 2013 4:49 pm

I have a handel, but it has a console just like that attached to it, sorry no spair but I'll keep my eyes out for one.
Jackpot :oops: #-o :lol:
I Buy-sell-trade coin op's. I also have some later model slot parts. There are piles of manuals at:
http://coinslots.com/page21.html
Jackpot
 
Posts: 94
Joined: Wed Nov 24, 2004 9:15 am
Location: Shoreline Washington

Re: Handle for Jennings console slot wanted

Postby tsparts4u » Sun Jan 27, 2013 5:15 pm

Hi,
There was a handle post on ebay recently. Unfortunately, it was a broken one, and the darn things are made out of some sort of pot metal, that can't be welded, and I don't think gorilla glue is the answer, ha! I guess, I'll just have to keep waiting, and hoping.
tsparts4u
 
Posts: 223
Joined: Fri Mar 02, 2012 6:58 pm
Location: Franklin, WI

Re: Handle for Jennings console slot wanted

Postby Jackpot » Sun Jan 27, 2013 6:00 pm

How about this stuff for welding pot metel? Anyone ever try anything like this? :arrow:

http://www.ebay.com/itm/USA-Welding-Rod ... 1c1e4bdbe9

Jackpot :roll: :roll: :roll:
I Buy-sell-trade coin op's. I also have some later model slot parts. There are piles of manuals at:
http://coinslots.com/page21.html
Jackpot
 
Posts: 94
Joined: Wed Nov 24, 2004 9:15 am
Location: Shoreline Washington

Re: Handle for Jennings console slot wanted

Postby Mike Gumula » Mon Jan 28, 2013 8:35 am

I'd also be interested in knowing if anyone has tried this pot metal welding rod , and was successful with it. I have a 2 inch in diameter, round ball shaped pot metal piece that a long threaded rod went through that has a crack in it from being over tightened, that I want to repair it, or have it repaired. It was part of a base stand for a smoking table. I was thinking of JB Weld, but this might be better, but I'm nervous about trying it and ruining the piece. Advice or suggestions please ?
Mike Gumula
Mike Gumula
 
Posts: 29
Joined: Wed Nov 17, 2004 5:51 am
Location: Graham , NC


Return to Machines Wanted

Who is online

Users browsing this forum: No registered users and 8 guests

cron