CoinOpCollectorForum.com

New, repro, exact fit back door for Zephyr. Semi-gloss black, w/o lock.
Shipped Priority: $80.00.

I'll go $25 plus $5 shipping.
Jim

Hi Jim, Thanks for the offer. It doesn't eat much...so I'll keep it. Ya never know, I might run by another Zephyr. Mike

Actually, there is one on ebay right now in decent shape that needs a back door. I think it ends in the next day or 2, but it might be a good deal and a good mate for your door.
Jim

Jim, ...and there's a rather large spread between with and without the door. Mike

Hi Mike;
I just checked those two Zephyrs on ebay; the one with door sold for $307.11; the one with no door sold for $112.50.

For the purposes of our discussion, the question is "How much of the difference is due to one having an original back door?"

Hard to say because there was a big difference in the condition of the machines; the one with door was either restored or in Exc/complete/working condition; the one with no door needed retoration inside and out; paint was shot, alot of rust inside and missing at least a few springs in addition to the back door.

My offer on your replacement door (it would more properly be called a replacement rather than repoduction since it does not have the gum filler hole/flap or coin release plunger) was not intended to be lowball/insulting and I don't think you took it that way; I just thought that's about where it should be. I admit that I have not been to any shows/meetings for years; the last door I bought was a repo back for a Columbia slot for $30, but that was at least 6 years ago.

At any rate, if replacement doors are going into the $80 range, I may just make up a batch, one for my machine and the rest to sell. The Zephyr (and Columbia slot) back doors would be among the easiest to copy. Obviously, you either made the one you have or got it from someone who made one or more, so there may be more floating around out there.

Are we the only ones on this thread? Anybody else got an opinion (or back doors to sell)?

Jim

Hey Jim...it's just us here. You can look up the thread in a prior post and see what it cost me. Granted I over paid, but after years of looking, I only wanted to complete the machine. There have been two manufacturers of repro doors I know of. I found one in the Netherlands and one local. In any case, when the production run is out, can you get another? THe second door I bought is an exact dupe of the original.
Mike

The door is on eBay if anyone's interested:
http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... :MESELX:IT