Page 1 of 1
Mills Fok needs a weld
Posted:
Tue Feb 02, 2016 5:18 pmby sam2002
looking for someone that can weld a broken goosneck top casting . Narrow side of the upper casting has been broken off , left side looking from back . About 2 inches back it was broke when found .
thanks
Sam
Re: Mills Fok needs a weld
Posted:
Tue Feb 02, 2016 6:18 pmby oldslotman
John's Custom Fabrication Blooming Mn. I believe fellow member on here, terick2104, has used him. Might want to contact him about it.
Re: Mills Fok needs a weld
Posted:
Wed Feb 03, 2016 4:37 amby terick2104
Yes I have used him for over 20 years on castings and mechanisms. He does fabulous work, I have had castings that were missing chunks out of the castings that he repaired and I couldn't see where the repair was. I have had several goosenecks repaired by him also. Check out his web sight, put Johns Custom Fabrication in you search engine.
His phone # is 952-888-2322
Re: Mills Fok needs a weld
Posted:
Wed Feb 03, 2016 3:27 pmby sam2002
Will check into this .
Thank you !