Page 1 of 1

Mills Gooseneck Assistance Needed

PostPosted: Sun Apr 12, 2020 2:35 pm
by notagator
I know this is probably a fairly simple question but do the pins in the one picture (shown by red straws) go in the holes (shown by toothpicks) in the other picture? The upper pin won't line up without some bending and I don't want to go adjusting things I don't understand.

In my defense, the gooseneck was broken off and hanging when I got it. Additionally, I think it was dropped on it's side at some point in time and things don't line up as they should.

I had the top of the casting where the coin handling mechanism mounts welded back together as you may see.

Your serious comments and suggestions are appreciated. Thanks for your help.

Garry

Re: Mills Gooseneck Assistance Needed

PostPosted: Sun Apr 12, 2020 4:17 pm
by ThirdGenAmusement
I scanned in what I believe to be what your looking for. So see attached pic for more info but it appears one is for the check detection and one is for the coin seperation.

Re: Mills Gooseneck Assistance Needed

PostPosted: Sun Apr 12, 2020 7:38 pm
by notagator
Perfect! Just what I need to know. Thanks.