CoinOpCollectorForum.com

Hello, I am looking for help. I purchased a modern slot machine stand. The glass / plexiglass with the thin film adhesive picture is missing on the front. Where would a go to take a current picture or picture with glass adhered to get a replacement made. Is is possible to just take one out of an existing stand to someplace that would take a photo. Then use this to create on a thin film laminate that could be installed on glass or plexiglass. It this a standard process. Thanks for your help.
Scott

This was just an example. Mine is missing the glass and has different dimensions.
Scott

Not sure what kind of Slot Stand/cabinet you have with no photo but if it is similar to the one you posted here on the forum you may want to check with Mike Studebaker as he may have a direct replacement glass panel you can use rather than go to the expense of scanning and producing one for you!
He is one of the "Old Timers" who has been making these stands for many years!
His contact information below;
https://specialtystands.com/

BONA FORTUNA!
MONTI

Glass is 14 inches tall and 12 inches wide. I did send a message to Mike.

I was able to contact my local graphics printing company and get one made. I went to my local hardware store and got some plexiglass. I now have my broken slot machine stand back in tip top shape. Thanks for the ideas and help!