MONTI wrote:Rick,
My thought on this is as follows which I pass on to my Bally E/M slot service/repair customers as well!
Yes, in a casino environment three things were common:
1. Being in a controlled temperature environment which most casinos had set at approximately at 66 to 68 degrees where possible, at least the ones I worked in, to keep the players active on all gaming levels, slots, tables, etc. Not to hot to tire them out but not too cold to make them uncomfortable, so they would keep playing and spending money!
2. Other than sporadic play on the Graveyard shift, the slots where played continually on a regular basis keeping them "Limbered Up" so to speak!
The ones in the corners and not played often where actually more susceptible to visiting us in the slot shop!
3. Using the original lighting, especially the 6 V.Ac circuit bayonet style bulbs which produce and emanate heat the inside parts remained warm so the lubricant used was a little, slightly, of a heavier consistency which continuos play and warmth was appropriate!
Now in home usage to go over the points again;
1. Slot machines should be kept inside the residence not in an outside shop or garage in the winter time with no heat as a cold environment with little play or
2. Not enough play can cause mechanical portions, specially in the E/M variety slots to have a tendency to "malfunction" in areas of over lubrication, coil switching areas, Etc.
and 3.
Some folks like to use LED bulbs to replace the original bulbs and yes while they last longer they do not provide that little amount of warmth the original bulbs did and lubrication should be very light and almost non existent! These slots were designed for these bulbs which did supply a little warmth, not much but it helped!
I have customers who have large collections of the early Bally E/M slot machine and they leave them on all the time and actively play them often however the ones I see in the shop were in a cold environment, not even plugged in and stored which require a thorough cleaning, adjusting and light lubrication!
Sorry to get so long winded and if I missed anything someone else here will correct me or comment, which I thoroughly respect!
Bona Fortuna!
MONTI
RoudyRick wrote:Monti, Read your reply and agree with what your saying for MECHANICAL machines but what about the electronic ones? I have heard that leaving those on at home with little use tends to wear down the electronics and calls for electronic part replacements much more often. I currently have both my electronic ones on timers (on at 0900 off at 2200) and my lighted Jennings mechanical s on timers to preserve the bulbs life. Our house is about the same temp as the casinos you mentioned. (prefer to be COOL ) My collection consists of one mechanical machine for each US coin and the electronic ones are both 25 cent.
Bally Bill wrote:Hi Monti, I always wondered if the casinos shut down E/M machines during the late hours of the night (2-5 am) and didn't think of the internal heat from the lamp bulbs would help with the lubrication on the mechanism. I have 4 E/M slots indoors and I turn them on from about an hour everyday then play all of them for about 30-45 mins and then shut them off 30 min after we are finished. We keep record of the big jackpots on a calendar to see how close they hit from year to year and its pretty interesting to see how they repeat within 2 to 3 days of last year's wins. Thank you for providing the insight of casino gambling strategies towards the players and the operation of the E/M slots during that time period.
Return to Repair / Restoration Questions
Users browsing this forum: No registered users and 27 guests