Handle for Jennings console slot wanted
Posted:
Sun Jan 27, 2013 2:15 pmby tsparts4u
WANTED:
I'm in need of a handle for a Jennings console slot machine like the one in the picture below. Can anyone help?
Re: Handle for Jennings console slot wanted
Posted:
Sun Jan 27, 2013 4:49 pmby Jackpot
I have a handel, but it has a console just like that attached to it, sorry no spair but I'll keep my eyes out for one.
Jackpot
Re: Handle for Jennings console slot wanted
Posted:
Sun Jan 27, 2013 5:15 pmby tsparts4u
Hi,
There was a handle post on ebay recently. Unfortunately, it was a broken one, and the darn things are made out of some sort of pot metal, that can't be welded, and I don't think gorilla glue is the answer, ha! I guess, I'll just have to keep waiting, and hoping.
Re: Handle for Jennings console slot wanted
Posted:
Sun Jan 27, 2013 6:00 pmby Jackpot
Re: Handle for Jennings console slot wanted
Posted:
Mon Jan 28, 2013 8:35 amby Mike Gumula
I'd also be interested in knowing if anyone has tried this pot metal welding rod , and was successful with it. I have a 2 inch in diameter, round ball shaped pot metal piece that a long threaded rod went through that has a crack in it from being over tightened, that I want to repair it, or have it repaired. It was part of a base stand for a smoking table. I was thinking of JB Weld, but this might be better, but I'm nervous about trying it and ruining the piece. Advice or suggestions please ?
Mike Gumula
