Need help identifying a Buckley slot machine part

[bakerb95619]

I just received a 5c Buckley Criss-Cross slot machine via FedEx. The packaging was excellent so it arrived in good shape, however the part below fell out and I can't see where it belongs. It has 1 threaded end, a notch at the other end, and a small hole 3/8 of an inch from the notched-end. It is 2" long:


There is also a larger broken spring. I see the same springs on the back of the mech, but can't see where it would be missing from. The spring is 2 1/2" long (total):

[Dave]

The pin looks like the pin that holds the vertical finger reset.

The spring looks like the spring that is connected to the clock.

[bakerb95619]

Hello Dave, thanks very much, the pin was to hold the payout fingers at the back. That explains why every pull was paying out 18 coins, winning combination or not.
I had to find a small nut and lockwasher for the pin, but I got it all back together and all payouts work correctly now including the token vendor for BAR-BAR-BAR.
Thanks again,
Bill

[Dave]

Hello Dave, thanks very much, the pin was to hold the payout fingers at the back. That explains why every pull was paying out 18 coins, winning combination or not.
I had to find a small nut and lockwasher for the pin, but I got it all back together and all payouts work correctly now including the token vendor for BAR-BAR-BAR.
Thanks again,
Bill

Yep, your right. I forgot about the pin for the horizontal payout fingers.

Did you find where the spring went?

Dave

[bakerb95619]

No, didn't find anywhere for teh spring. I have another Buckley machine and checked it's mech, and couldn't find anywhere for the extra spring. Maybe it was replaced with another one before I received it.