Bally Bill wrote:99623 wrote:Today I have been working on the machine sitting in the cabinet, it was not fitting in the lower piece that it locks into. I have no idea how it happened, however it was like this when I bought it, after a few hours of adjusting it, it is perfect. No nuts, bolts, anything, was out of place.
It also helps to have the hold down screws to keep reel mechanism in place (Right top and left underneath)
Bally Bill wrote:making some nice strides in your restoration, it's nice to have the check detector on your machine but most have been removed to make the escalator cycle consistently. Did you cycle this on the bench before your installed it?
Users browsing this forum: No registered users and 2 guests