Mills gooseneck screws

[YourBestBet]

Hi everyone,

I need to replace the top two screws on the gooseneck of a Mills poinsettia. Anyone know the correct screw type or best place I can locate them?

Thanks!

[watlingboy]

They are called philister head screws. I don't have a Mills to check but I believe they are 10/24 thread, could be 8/32 but you can screw a regular round head screw in to check size and length. They are approximately 3/4 or 1 " in length. I'll bet some forum folks have some extras. You can still get them at good old fashioned hardware stores but won't find them at Orchard or the chain hardware stores.

Watlingboy

[terick2104]

I have them - they are a 10/24 x 1/2 - they are also available from McMasters and Carr they have a websight but they only sell them in boxes of 100. Give me your address or phone # and I will send you some if you only want a few.

[SLOT DYNASTY]

I have them - they are a 10/24 x 1/2 - they are also available from McMasters and Carr they have a websight but they only sell them in boxes of 100. Give me your address or phone # and I will send you some if you only want a few.

terick2104:
I have sent 'YourBestBet' an e-mail, and offered to send him the correct Philister-Head screws as well.
The ones I have are stainless, so if you hit them on a buffer, they will polish like chrome, and will never rust.
Also, PM me your phone #, as I have to talk to you about 'you know what'.
Bill

[YourBestBet]

Thanks watlingboy, terick and slotdynasty. You are all very helpful.

I want to make sure I'm looking at the correct screw type. Here's a link to the website terick provided: http://www.mcmaster.com/#machine-screws/=s7vr1i
Looks like they offer Type 316 stainless steel and 18-8 stainless steel. Am I looking at the correct slotted screw here?

I just tried the link and it doesn't take you to the exact screw. I'm looking at a round head slotted machine screw, 10-24, 1/2 inch. stainless steel.

[oldslotman]

Fairway fasteners also has them.

[YourBestBet]

thanks oldslotman. looks like fairway fasteners has fillister head screws.

[YourBestBet]

If anyone else needs fillister head screws for a gooseneck machine, I believe I found the most cost effective outlet.
I purchased these on Amazon and they arrived yesterday. They work great. If you have an Amazon Prime account it's free two day shipping so 100 screws cost me under $10.

Search this on Amazon: Stainless Steel Machine Screw, Plain Finish, Fillister Head, Slotted Drive, Meets ASME B18.6.3, 5/8" Length, Fully Threaded, #10-24 Threads (Pack of 100)

http://www.amazon.com/dp/B000FN5YYY/ref ... 1_ST1_dp_1

[fast_in_muskoka]

Howdy,

I could use a few of these for my Skyscraper . . .

Anyone willin to mail a few to north of the border, just let me know and I'll send some $.

regards,

Steve

[leospanner]

I just ordered a box of 100, but only need a few. Anyone that would like a few please let me know, only charge is for mailing.

Leo at leo_spanner@hotmail.com